As a Brazilian granulite, Verde Eucalypto is a robust hard rock with a low water absorption (0.18 %), acid resistance and frost resistance confirmed by DNSA, and the particularity that the compressive strength even rises slightly after freeze-thaw cycle loading (168 → 182 MPa). Wine, lemon juice, vinegar, cola, sanitary cleaners or descalers leave no etch marks as they do on marble or limestone.
For interior applications we recommend an impregnation on a silane or polysiloxane basis at first installation. On polished surfaces, depending on use, 5-10 years can lie between refreshings of the impregnation; on heavily used kitchen worktops or exterior applications, check every 2-3 years. Impregnation protects against the deep penetration of oil, grease and pigments — on the pale sage-green ground mass, discolourations can otherwise show up visibly.
Day-to-day care is carried out with a pH-neutral natural stone cleaner and a soft cloth or microfibre mop. Clean warm water is usually enough. Acidic cleaners are in principle unproblematic, but should nevertheless not be used, because they can attack the impregnation. The surface finishes available from stock are listed in the »Finishes« block further down.
For kitchen worktops Verde Eucalypto is very well suited: resistant to cutting and scratching, insensitive to heat (hot pots and pans can be set down directly for short periods; longer heat exposure above 200 °C should nevertheless be avoided), acid-resistant as confirmed by DNSA and with good stain repellency. The pale sage-green surface conceals small crumbs and wipe streaks moderately well — on kitchen surfaces we recommend consistent daily cleaning. The surface finishes available from stock are listed in the »Finishes« block further down. With the low water absorption (0.18 %) and a compressive strength that even rises slightly after freeze-thaw loading, the stone is fully weather-stable — ideally suited to exterior façades, terraces, stairs and pool areas.
For pool surrounds, exterior terraces and fountain surrounds a slip-inhibiting textured surface is mandatory — on smooth exterior surfaces there is a high risk of slipping when wet. In areas with frequent salt contact (road salt, pool chlorine) we recommend an additional annual refreshing of the impregnation.